Step-by-Step Guide to Using the Uwell Crown IV Mod (Crown 4 Mod) 200W

Sub-ohm enthusiasts who love to customize every aspect of their vaping experience can’t stop raving about the Uwell Crown IV Mod (Crown 4 Mod) 200W.  This highly coveted vaping device comes with loads of thrilling features and an extremely sturdy construction. 

If you’re one of the lucky vapers who recently purchased the Crown IV, this guide is for you. We’re going to walk you through the steps to using this device so that you can experience the most satisfying vape of your life.

Step #1: Remove the Uwell Crown IV Mod from its box. Keep the other components in the box and place the box somewhere safe. The other components will come in handy at a later time.

Step #2: Open the hinged battery door that’s on its base. Into the battery compartment, insert two fully charged 18650 batteries. Then, securely shut the battery door.

Step #3: Grab the sub-ohm tank that you want to use with this mod. Insert a fresh, primed coil into the center of the tank.

Step #4: Fill it with vape juice until you’ve reached the maximum fill line.

Step #5: Screw the sub-ohm tank into mod’s 510 threaded connection. Make sure that it’s screwed tightly enough for the connection to be secure.

Step #6: Turn on your Crown IV by pressing the power button the proper number of times. How many times you should press the power button can be found in the user manual that comes with this mod.

Step #7: Begin programming your settings. The large OLED display screen makes it easy for you to set your various preferences. In addition to a wattage mode, this device boasts a temperature control suite as well as various output modes.

Final Step: Use the firing button to take your first hit. 

The Uwell Crown IV Mod (Crown 4 Mod) 200W is an exceptional box mod that will give you the sub-ohm experience that you crave.